In this final blog of our Adams-EDEM co-simulation series, Darren Simoni from DSIM Technologies explains how EDEM and Adams have been used during the design of a skid-steer loader to increase the accuracy of system level simulation using less time and effort than traditional load estimation methods.
While additive manufacturing of reinforced polymers is appealing and increasingly considered for production of actual parts, major obstacles must be overcome by engineers. Dimensional accuracy of the part must obey to strict tolerances that may not be met due to thermally induced part distortion or poor surface roughness. On the material side, an anisotropic material behavior is brought in by the specific 3D printed layered architecture and oriented reinforcements. This process-induced material behavior make the part mechanical response challenging to predict.
Therefore, Digimat, the material modeling platform, can offer you a solution to overcome your challenges.